Hello, I am changing to a newer case and need the internal connector info for the H-JOSHUA-H61-uATX Mainboard 670960-001. I am unable to find a manual for this.
Hi, I have been using the above mobo for a couple of years, but it recently died (no video from either Video card or onboard video) I have scoured the web, and in particular the foxconn site but can't find any info. This maybe because the board was made for the HP Pavilion HPE?
I am looking for a user manual, or at the very least information on the headers and jumpers. I have just received a replacement board, but will be away for a couple of weeks so I haven't got time to fire it up.
One thing I did notice was that in my messing around with the old board, I appear to have got the jumpers on the CLR-PASS and CLR_CMOS on wrong. Instead of having them on 1-3 and 2-4 I had them on 1-2 and 3-4. Before I played with these jumpers the board showed some signs of life (it would boot up and run fine until it was powered off then it would take a few power on attempts to get it working again, is it likely that this mistake could have been the final nail in the coffin?
Finally, there is a BIOS recovery jumper, and a one time recovery header, how do these work?
Thanks for any input, I may not be able to reply for a few days.
ex-egll
I am looking for a user manual, or at the very least information on the headers and jumpers. I have just received a replacement board, but will be away for a couple of weeks so I haven't got time to fire it up.
One thing I did notice was that in my messing around with the old board, I appear to have got the jumpers on the CLR-PASS and CLR_CMOS on wrong. Instead of having them on 1-3 and 2-4 I had them on 1-2 and 3-4. Before I played with these jumpers the board showed some signs of life (it would boot up and run fine until it was powered off then it would take a few power on attempts to get it working again, is it likely that this mistake could have been the final nail in the coffin?
Finally, there is a BIOS recovery jumper, and a one time recovery header, how do these work?
Thanks for any input, I may not be able to reply for a few days.
ex-egll